CRATE LATE MODELS

RULE BOOK DISCLAIMER

The rules and/or regulations set forth herein are designed to provide for the orderly conduct of racing events and to establish minimum acceptable requirements for such events. These rules shall govern the condition of all events, and by participating in these events, all participants are deemed to have complied with these rules. NO EXPRESSED OR IMPLIED WARRANTY OF SAFETY SHALL RESULT FROM PUBLICATIONS OF OR COMPLIANCE WITH THESE RULES AND/OR REGULATIONS. They are intended as a guide for the conduct of the sport and are in no way a guarantee against injury or death to a participant, spectator or official.

The race director shall be empowered to permit reasonable and appropriate deviation from any of the specifications herein or impose any further restrictions that in his/her opinion does not alter the minimum acceptable requirements. NO EXPRESSED OR IMPLIED WARRANTY OF SAFETY SHALL RESULT FROM SUCH ALTERATION OF SPECIFICATIONS.  Any interpretation or deviation of these rules is left to the discretion of the officials. Their decision is final.

The Management of MOUNTAIN VIEW RACEWAY

 

BODIES:

  1. Lucas Oil, SAS body rules apply

  2. Top deck height max. 38 inches from ground up. Will be measured all the way across the rear at T-bar.

  3. 8 inch spoiler and sides max. 8 inch of flat material, 602 & 604.

  4. Minimum wheel base 103 inches

TIRES:

  1. Fronts open. Rears – Hoosiers 1600/Equivalent or AR56/Equivalent.

  2.  Must be shoulder plated and stick a minimum of 50 at any time. NO tolerance.

  3. No grinding off shoulder plate numbers

  4. No chemical treatment of any kind allowed

*Tire samples will be taken

SUSPENSION:

  1. All Lucas Oil, SAS suspension rules apply

  2. Carbon fiber drive shafts allowed

  3. All parts must be steel or aluminum. NO titanium parts allowed

FUEL:

  1. E-85 or racing gas only.

*Fuel samples will be taken.

ENGINE AND WEIGHT:

  1. All engines must be sealed and meet GM factory specs. NeSmith engine rules apply

  2. 604 1 inch carb spacer max. 2300 lb

  3. 602 2 inch carb spacer max. 2200 lb

  4. No Tri-Y headers

  5. Engine placement max. 6 inches, +/- 1 inch from ball joint to #1 plug

  6. Any carburetor allowed

TRANSMISSION:

  1. Any transmission

  2. Any bellhousing allowed

  3. Rear drive pumps allowed

REAR END:

  1. Aluminum or Steel. No titanium parts allowed.

WHEELS:

  1. Any inch aluminum wheel allowed. NO carbon fiber

ALL PROTEST RULES APPLY, VIEW IN GENERAL RULES

© 2019 by Mountain View Raceway.

Proudly created with Wix.com

Like us!
  • Facebook Social Icon

Text :

423-507-2619 

Spring City , TN